Sharp AR-207 AR-207 Operation Manual - Page 66
Self-diagnostic function - code
View all Sharp AR-207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
COPIER TROUBLE? Problem Power is on but copying is not possible. Lighting fixture flickers. Solution q Is the output tray full ( ) indicator on and any misfeed location ( ) indicator blinking while the misfeed ( ) indicator is not blinking? Remove the paper on or under the job separator tray so that it can move to the proper position, and then open and close the side cover. q Is two-sided printing being performed? Wait until the printing job will finish. q Is blinking in the copy quantity display? q Is steadily lit in the copy quantity display? q Is the indicator blinking? q Is the indicator blinking? The toner cartridge is not installed. Install the toner cartridge. If "CH" is blinking even if the cartridge is installed properly, contact your SHARP service center immediately. Side cover(s) is open. Close the front and side covers securely. The toner cartridge must be replaced. See page 42, TONER CARTRIDGE REPLACEMENT. A misfeed has occurred. See page 44, MISFEED REMOVAL. q Is the same power outlet used for the lighting fixture and the copier? Connect the copier to a power outlet which is not used for other electric appliances. 64 Be sure to use only genuine SHARP parts and supplies. Please contact your SHARP service center immediately if a problem persists after checking the above. Self-diagnostic function An automatic self-diagnostic function is built into the copier. Should the copier malfunction, the self-diagnostic function will locate the problem and stop the copier to prevent damage. An alphanumeric code will appear in the copy quantity display. Example Should the copier completely stop and a letter and a number appear alternately, contact your SHARP service center immediately. GENERAL INFORMATION Copier trouble?