Sharp AR-287 AR-287 , AR-337 , AR-407 Operation Manual - Page 101
Self-diagnostic function - error codes
View all Sharp AR-287 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
TROUBLESHOOTING 5 CHAPTER Problem Solution Dust, dirt, smudges appear q Document glass, RADF transport Clean regularly. See page 6-6. on copies. belt dirty? Touch panel is too dark or q Is LCD contrast properly too light. adjusted? Adjust the LCD contrast. See page 6-7. "CHECK THE SUB MACHINE." message appears and the tandem copying does not start. q Some message appears on the touch panel of the sub copier? Follow the message on the sub copier to solve the problem. "THE SYSTEM IS NOT CONFIGURED TO PERFORM TANDEM JOB. CODE: XX" message appears and the tandem copying can not be performed. q The same options are equipped for the main and sub copiers? q The settings in the following key operator programs are different on the main and sub copiers: * Disabling of Duplex Copying (error code No. 51) * Disabling of Stapler (error code No. 52) * Disabling of Bypass-Tray When Offset Tray Selected (error code No. 53: only with AR-FN2) Tandem copying is not performed unless the same options are equipped for both main and sub copiers. Tandem copying is not performed unless the settings in these key operator programs are the same on both main and sub copiers. If a problem persists after checking the above, please consult your authorized Sharp Service Center. Self-diagnostic function An automatic self-diagnostic function is built into this copier. Should the copier malfunction, the self-diagnostic function will locate the problem and stop the copier to prevent damage. An alphanumeric code will appear in the message display. Example Should the copier stop completely, and the message "CALL FOR SERVICE. CODE: " appear in the message display, contact your authorized Sharp Service Center. 5 KEY OPERATOR See page 29 of the KEY OERATOR'S GUIDE. 5-13 COPIER TROUBLE? Troubleshooting