Sharp AR-287 AR-287 , AR-337 , AR-407 Operation Manual - Page 138
Insert a new sheet of paper 8-1/2 x 11 or A4 size
View all Sharp AR-287 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
FINISHER (AR-FN2) Staple cartridge replacement The message "ADD STAPLES." will appear when the staple cartridge is empty. Replace the staple cartridge as follows: 1 Open the stapler cover. OPTIONAL EQUIPMENT 7 Finisher (AR-FN2) CHAPTER 2 Lift the green release lever and remove the staple cartridge from the stapler. q A few staples will be left in the cartridge. Remove and discard them. 3 Insert a new sheet of paper (8-1/2" x 11" or A4 size) to the tray as shown in the picture to make the stapler work properly. STAPLE TEAR line 7-26 4 Check that the first staple in the new cartridge is at the tip of the cartridge. q If the first staple is not at the tip, pull it to the tip. If any staples are protruding past the cartridge tip, tear them off at the STAPLE TEAR line and align the first staple with the tip. q A cartridge holds 5,000 staples. 5 Push the new staple cartridge in until it clicks in place. 6 Close the stapler cover. q The stapler will strike three times without stapling and feed staples automatically. q Remove the paper from the tray. q To check that the stapler works properly, copy an original and staple it.