Sharp AR-5316 AR-5316 Operation Manual - Page 55

REPLACING THE TD CARTRIDGE When the TD cartridge replacement required indicator ( ) lights up, the TD cartridge will need replacement soon. Obtain a new cartridge. When the TD cartridge replacement required indicator ( ) blinks, the TD cartridge must be replaced before copying can be resumed. Replace the TD cartridge by following the procedure below. Note When the TD cartridge replacement indicator ( ) lights up, little toner remains and thus copies may be faint. 1 Push on both ends of the front cover and open it. 4 Remove the protective cover from the TD cartridge by unlatching three cover hooks from the holes on the cartridge and then pulling the cover in the direction indicated by the arrow in the illustration. 2 Pull the TD cartridge out while pulling up on the lock release lever. TD cartridge lock release lever Pull out the TD cartridge until the green strap handle can be grasped. While supporting the TD cartridge at the green label with your left hand, grasp the green strap handle with your right hand and pull the TD cartridge all the way out. After removing the TD cartridge, do not shake Caution it or tap on it. Doing so may cause toner to leak from the cartridge. Put the old cartridge immediately in the bag contained in the box of the new cartridge. Dispose of the old TD cartridge in accordance with local regulations. 3 Remove the new TD cartridge from the bag. Grasp the cartridge on both sides and shake it horizontally four or five times. 4 or 5 times 5 5 Insert the TD cartridge along the guides until it locks in place. If there is any dirt or dust on the TD cartridge, remove it before installing the cartridge. 53