Sharp CD-SW200 CD-SW200 Operation Manual - Page 12

CD-SW200 System connections (continued) Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM 75 OHMS terminal and position the FM antenna wire in the direction where the strongest signal can be received. Supplied AM loop antenna: Connect the AM loop antenna to the AM LOOP jack. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). ANTENNA AM FM 75 OHMS GND LOOP Speaker connection FRONT SPEAKERS: Connect the black wire to the FRONT SPEAKERS minus (-) terminal, and the red wire to the FRONT SPEAKERS plus (+) terminal. SUBWOOFER: 1. Connect the black wire to the SUBWOOFER minus (-) terminal, and the red wire with purple insulation tube to the SUBWOOFER plus (+) terminal. Red Black Red Black 2. Connect the subwoofer light-up wire to the SUBWOOFER LIGHT-UP jack. SUBWOOFER Preparation for Use Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. Installing the AM loop antenna: < Assembling > < Attaching to the wall > Wall Screws (not supplied) Caution: Never mistake the FRONT SPEAKERS and the SUBWOOFER terminals. The unit or the speakers may be damaged. If you use other speakers with an impedance lower than that specified, the unit may be damaged. Front speakers: 6 ohms, Subwoofer: 12 ohms. Do not mistake the right and the left channels. The right speaker is the one on the right side when you face the unit. Do not let the bare speaker wires touch each other. Do not stand or sit on the speakers. You may be injured. Do not allow any objects to fall into or to be placed in the bass reflex duct. Incorrect 12