Sharp DT-200L Operation Manual - Page 17
Power ON/OFF, Zooming and Focusing
View all Sharp DT-200L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Setup & Connections Power ON/OFF POWER buttons TEMP. LAMP POWER Press POWER ON. • The blinking green LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops blinking before operating the projector. • If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on. • After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust ventilative hole. This odor will soon disappear with use. When the power is on, the LAMP REPLACEMENT indicator illuminates, indicating the status of the lamp. Green: Lamp is ready. Green blinking: Warming up. / Cooling down. Red: Change the lamp. Press POWER OFF. • Press POWER OFF again while the confirmation message is displayed. Then, message "Terminating. Please wait." will appear. • If you accidentally pressed POWER OFF and do not want to turn off the power, wait until the confirmation message disappears. • When POWER OFF is pressed twice, the POWER indicator will illuminate in red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode. • Wait until the cooling fan stops running before disconnecting the power cord. • The power can be turned on again by pressing POWER ON. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicators illuminate in green. A dimly lit screen is displayed for a short time (about 20 seconds) to reduce lamp damage. Zooming and Focusing The picture can be zoomed in or out, and focused by the Zoom knob and the Focus ring. 1 DT-200 2 1 Slide the Zoom knob. The image can be adjusted to the desired size within the zoom range. 2 Rotate the Focus ring until the image on the screen becomes clear. DT-200(E)#p15_21.p65 16 02.11.21, 11:30 AM E-16