Sharp DV-R550U Operation Manual - Page 37

Before you start Connections Getting started Recording Recording Timer Recording (cont'd) If the timer program did not complete correctly, the error number appears on the timer programming list. Timer Programming VCR DVD  Date * JAN/01 2. --- Start End CH DVD VCR Speed 12:57AM 1:57AM 8 DVD E22 3. --- Each error number means: E1-22 Recording error other than E36 E37-39 below E23-24 Unrecordable disc E40 E25-28 Copy prohibited program E29 Disc protected E30 Disc full E31-32 Already 99 titles recorded E33 Already 999 chapters recorded E34 No space for Control information E35 PCA full E41 E42 Error number will appear Already finalized Video format disc Some portion has not been recorded because of program overlapping. Recording did not start at the start time. No videotape is inserted. Videotape ran out during recording. Power failed No disc when recording Note • A program with the error number is highlighted in gray of the asterisked line in the timer programming list. • Once the timer programming list with error indication is displayed, the program line(s) with error will be cleared only after the programs are canceled and reset to the timer standby mode. • The current recording program will be highlighted in red. Playing discs Editing Changing the Setting menu VCR functions Others Español Explanation on the front panel indicator during Timer Recording (CLOCK) mark VCR mark DVD mark Lights off Lights on Flashing Lights off Lights on Flashing Lights off Lights on Flashing - An OTR is completed, and there is no other timer recordings in standby. - The timer standby mode is cancelled by pressing T-SET. - POWER is pressed during timer standby, and the component that is not in timer standby mode is turned on. - The unit entered into the timer standby mode. - A Timer Recording or an OTR has started. - When this indicator is on, you cannot use SET UP. - All timer recordings are completed. - All VCR Timer Recordings are completed, and there is no other timer recordings in standby. - A VCR Timer Recording is cancelled by pressing STOP/EJECT C/A on the unit. - The VCR timer standby mode is cancelled by pressing T-SET. - POWER is pressed during VCR timer standby, and the unit switched to the DVD mode. - The VCR entered into the timer standby mode. - The VCR entered into the timer standby mode when no tape or a tape without an erase protection tap is in the unit. - The tape runs out during Timer Recording. - All DVD Timer Recordings are completed, and there is no other timer recordings in standby. - The DVD timer standby mode is cancelled by pressing T-SET.only momentarily. - POWER is pressed during DVD timer standby, and the unit switched to the VCR mode. - The DVD entered into the timer standby mode. - The DVD entered into the timer standby mode when no disc or an unrecordable disc is in the unit. - The disc runs out of the space during Timer Recording. Note • If the end of programmed time in DVD and a start of programmed time in VCR are the same, the indicator of the front panel may not be switched from DVD to VCR automatically. However, the Timer Recording for VCR is in progress normally. In such case, press OUTPUT SELECT on the front panel or VCR on the remote control to activate the display.This is not a malfunction. 37