Sharp EA242WU User Manual MultiSyncr - Page 9

English CAUTION Handling the power cord. Handle the power cord with care. Damaging the cord could lead to fire or electric shock. REQUIRED • When connecting the power cord to the product's AC IN terminal, make sure the connector is fully and firmly inserted. • Make sure the power cord cannot be easily disconnected. DO NOT TOUCH WITH WET HANDS • Do not connect or disconnect the power cord with wet hands. • When connecting or disconnecting the power cord, pull the power cord out by holding onto its plug. 1 • When cleaning the product, for safety purposes, unplug the power cord from the power outlet beforehand. Regularly dust off the power cord by using a soft dry cloth. UNPLUG THE POWER CORD • Before moving the product, make sure the monitor power is off, then unplug the power cord from the power outlet and check that all cables connecting the product to other devices are disconnected. HAZARDOUS VOLTAGE • When you are not planning to use the product for an extended period of time, always unplug the power cord from the power outlet. • This equipment is designed to be used in the condition of the power cord connected to the earth. If the power cord is not connected to the earth, it may cause electric shock. Please make sure the power cord is earthed properly. Please confirm the distribution system in building installation shall provide the circuit breaker rated 120/240 V, 20 A (maximum). 2 REQUIRED Do not bind the power cord and the USB cable. It may trap heat and cause a fire. PROHIBITED 3 REQUIRED Do not connect to a LAN with excessive voltage. 4 When using a LAN cable, do not connect to a peripheral device with wiring that might have excessive voltage. Excessive voltage on the LAN port may cause an electric shock. PROHIBITED Do not climb on the table where the product is installed. Do not install the product on a wheeled table if the wheels on the table have not been properly locked. The monitor may fall, causing 5 damage to the product or personal injury. PROHIBITED Installation, removal, and adjustment of the stand. • Handle with care when pulling the stand as it might pinch your fingers. REQUIRED • Before rotating the screen, disconnect the power cord and all cables from the product. 6 Otherwise, the power cord or cables might pull with excessive force and cause personal injury or damage to the product. • When rotating the screen, slide it to the highest level and set it to the maximum tilt. Otherwise, it could cause personal injury or knock the screen on the desk. Please check the Specifications for the available Tilt range when installing the product on a flexible arm. 7 Do not tilt the monitor downward beyond 5 degrees. Doing so can cause the LCD panel to separate PROHIBITED and potentially fall out causing damage to the product or personal injury. English−7