Sharp FP-N40CX FP-N40CX Operation Manual - Page 13

ENGLISH 2 Filter Installation 1 After the True HEPA Filter is removed from the plastic bag, and place it in the main unit with the tabs facing up. (See the diagram to the right.) Ensure that the filter is installed correctly. Do not install the filter backwards or the unit will not operate properly. 2 After removing the Washable Active Carbon Filter from the plastic bag, place it on top of the True HEPA Filter with the bands (2 places) located in the upper most corners. 3 Next, place the Pre-Filter through the bands (2 places) located in the corners of the Washable Active Carbon Filter. Insert the tabs of the Pre-Filter into the associated holes of the main unit. True HEPA Filter Tabs FRONT ·͑
Ensure the bands are uppermost Washable Active Carbon Filter Holes in the main unit Band Pre-Filter 4 Fill in the usage start date on the Date Label, which can be found near the upper edge of the Pre-Filter. Use the date as a guide for your Filter Replacement schedule. Date Label Tab(4 places) REMOTE CONTROL USE • Operate with the remote control facing the main unit (Receiver). • The signal range is about 23 feet (front). • Make sure there are no objects blocking the path of the signal. • A beep sound will be heard from the main unit when a signal is received. NOTE • Avoid dropping or damaging the remote control. In addition, be sure the remote control avoids moisture or place in direct sunlight or near a electric heater, etc., otherwise a malfunction may occur. E-11 Receiver Transmitter