Sharp HT-SB250 HT-SB250 Operation Manual - Page 11

AC power connection After checking all the connections have been made correctly, connect the AC power cord to the AC power input jack, then to the AC outlet. ■ Using with the AC/DC adaptor 1 Plug the AC power cord into the AC/DC adaptor. 2 Plug the AC/DC adaptor cable into the DC INPUT jack on the unit. 3 Plug the AC power cord into an AC outlet. AC/DC Adaptor Cable 2 Remote control ■ Battery installation This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply, California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/  Insert pin into the hole as shown and pull to open the battery holder. Pin Back of remote control DC INPUT jack (DC 12V) AC power cord LINE IN 2 RIGHT LEFT LINE IN 1 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. 1 AC outlet AC/DC Adaptor (AC 100 - 240 V ~ 50/60 Hz) Caution: If this product is to be used in other than 120 V region, please change the AC power cord to suit the region. Battery holder Polarity (+) symbol Battery type Locking tab Positive (+) side up The AC power cord part codes for 220 - 240 V region are as follow : 1) QACCEA002AW00 (For Europe and Latin America region) 2) QACCBA005AW00 (For United Kingdom Precautions for battery use: region) Remove the battery if the unit will not be used for 3) QACCLA002AW00 (For Australia region) a long period of time. This will prevent potential Notes: damage due to battery leakage. ● There will be no indication during power stand-by mode unless the ON/STAND-BY button is pressed. ● Unplug the AC/DC adaptor from the AC outlet if the unit will not be used for a prolonged period of time. ● Use only the supplied AC/DC adaptor. Using other AC/DC adaptor may cause an electric shock or fire. Caution: ● Do not use rechargeable battery (nickel- cadmium battery, etc.). ● Danger of explosion if battery is incorrectly replaced. ● Replace only with the same or equivalent type. ● Batteries (battery pack or batteries installed) E-10