Sharp HT-SB250 HT-SB250 Operation Manual - Page 9

System preparation (continued) 2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface  Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface. 1-1/4" (32 mm) ■ Installing the sound bar  Align the wall mount slot at the unit to the wall mount angle. 2 Slot the unit into the wall mount angle.  Fix them securely. Wall surface 3/8" (8-9 mm) Wall surface  Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces) Wall mount angle Wall surface Wall mount angle Placing the sound bar Installation image: TV HT-SB250 (screws x 4)(screws x 4) VCR DVD player Wall surface Wall mount angle Wall surface Note: Make sure all screws are fully tightened. (screws are not supplied) Place the unit as shown. Notes: ● As the sound from the unit is omni- directional, you can place the unit anywhere you like. However, it is recommended to place it as close to the TV as possible. ● The front panel of the unit is not removable. Caution: ● Do not change the installation direction when the unit is turned on. ● Do not stand or sit on the unit as you may be injured. E-