Sharp KC-830U KC-830U Operation Manual - Page 17

ENGLISH HUMIDIFYING TRAY Care Cycle 1 month Frequency of maintenance cycle will depend on the hardness of the water. Avoid spilling water when removing or cleaning the tray. 1 Remove the Water Tank and Humidifying Tray. Unlatch the Water Tank first, then remove the tray. Use both hands when pulling out the Humidifying Tray to avoid spilling water. When Water Deposits are Difficult to Remove 1 Fill Humidifying Tray halfway with lukewarm water, add a small amount of mild kitchen detergent, and leave to soak for about 30 minutes. Dilute detergent according to instructions on the container. Clean difficult-to-reach parts with a cotton swab or tooth brush. 2 Remove the Humidifying filter from the Humidifying Tray. Drain accumulated water by tilting the Humidifying Tray slowly. Humidifying filter Humidifying Tray 2 Rinse the Humidifying Tray with lukewarm water. • Rinse until all detergent residue is removed. • Inadequate rinsing may cause the detergent odor or changes in the shape/color of the main unit. 3 Rinse the inside of the Humidifying Tray with lukewarm water to remove impurities. • Do not remove the Styrofoam float. • Clean difficult-to-reach parts with a cotton- tipped swab or tooth brush. CAUTION • Use only mild kitchen detergents to clean the Humidifying Tray. Use of non-designated chemicals or detergents can cause deformation, tarnishing, cracking (water leakage). If the Styrofoam float comes off, replace by inserting the tabs of the Float into the holes in the Humidifying Tray as shown in the diagram. Insert the tab of the float into the hole. E-15 Insert the float below this tab. Insert the tab on the other side of the float into the hole.