Sharp LC-37HV6U LC-37HV6U Operation Manual - Page 12
Setting the Display on the wall, Setting the AVC System with the stand
View all Sharp LC-37HV6U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Preparation Setting the AVC System with the stand How to install the AVC System vertically using the stand unit. • Use the supplied stand unit for installing the AVC System vertically in an upright position. 1 Stick each spacer to the stand as shown. Peel each spacer away from the paper and attach to the four bulging areas on the stand. Stand spacer Bulge 2 Attach each cushion to the stand as shown. 3 Fit the stand to the AVC System. Peel each cushion away from the paper and attach to the four areas at the bottom. Stand cushion Attaching point Insert the stand into the AVC System, making sure that the thick and thin bulges of the stand align with the big and small holes on the AVC System. Thin bulge Bulge Attaching point Small hole Big hole Thick bulge 4 Attach the stand using the stand screws as shown. The AVC System installed vertically with the stand. Stand screw NOTE • When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when standing up directly on the floor or a flat surface as this can result in equipment failure. Setting the Display on the wall CAUTION • Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury. Using an optional bracket to mount the Display • You can ask a qualified service personnel about using an optional AN-37AG1 bracket to mount the Display to the wall. • Carefully read the instructions that come with the bracket before beginning work. Hanging on the wall AN-37AG1 wall mount bracket. (See the bracket instructions for details.) About setting the Display angle 5° • You can set the Display on the wall up to 5 degrees forward when the speaker is attached and up to 20 degrees forward when the speaker is not attached. Do not set the angle outside those ranges. Vertical mounting Angular mounting 11