Sharp LC-C4067UN LC-C4067UN Operation Manual - Page 7

QUICK REFERENCE Attaching/Detaching the Stand • Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal. • Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged. CAUTION • Attach the stand in the correct direction. • Do not remove the stand from the TV unless using an optional wall mount bracket to mount it. • Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. 1 Confirm that there are 8 screws (4 short screws and 4 long screws) and a hex key supplied with the stand unit. 2 Attach the supporting post for the stand unit onto the base using the box for the stand unit as shown below. • The supporting post attaches to the base at an off-centered location on the base. Be sure to attach the supporting post in the direction indicated below and attach the stand to the TV with the wider side of the base facing forward. Hex key Long screws Setting the TV on the Wall CAUTION • This TV should be mounted on the wall only with the AN-52AG4 (SHARP) wall mount bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries. • Installing the TV requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury. Using an optional bracket to mount the TV • You can ask a qualified service professional about using an optional AN-52AG4 bracket to mount the TV to the wall. • Carefully read the instructions that come with the bracket before beginning work. Hanging on the wall AN-52AG4 wall mount bracket. (See the bracket instructions for details.) 3 1 Insert the stand into the openings on the bottom of the TV. 2 Insert and tighten the 4 short screws into the 4 holes on the rear of the TV. Hex key Vertical mounting Angular mounting About setting the TV angle 0/5/10/15/20° • The "d" position is at the center of the display. • Refer to the operation manual of AN-52AG4 for details. 2 Short screws 2 Soft cushion 1 1 • Detach the cable clamp on the rear of the TV when using the optional mount bracket. • To use this TV mounted on a wall, remove the covers at the 4 locations on the rear of the TV, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the TV. • To detach the stand, perform the steps in reverse order. 7