Sharp MS722 Operation Manual - Page 12

To slog recording: Press the ti OFF button • II the unit is left alone after the reconl- ing has stopped, the power wit be fumed off about 2 minutes later. After recording: Press the OFF button whilst in the stop mode • After the track numbenas beer written on the discrthe power w il be turned ol automatically (For details about the TOC, see page 20.) To remove the MlnlDlsc: Turn oil the power and move the EJECT lever in the direction indicated by the • • Recording from a tuner or a CO (Manual recording) • Manual recordings oar be started are stopped as you lave. 1 Put the unit in the recording stand-by To interrupt recording: mode. (Perform slePS 1 - 4 • the Press the 11811 button whilst recording Syrchic recording section.; • The milell enter :be recording stand- 2 Preen the hill button by mode. • To resume recording press the tit • Recording will stan buttonagain. • To mcord nom a CD, press the sill Tie tram umber will be increased by bufton and then start playback or Pe one each lime you interrupt a record- equipment connected to to s unit • Track numbers can be created whist recording (Pane 17) Recordings can not he made in the following situations• Recording on a playback-on y MlniDlsc (commercially available ) • mIf uasMic incisc is protected against ac- cidental erasure (page at About the recording level: • If the recording level is too low, the playback sound volume may oe too low to hear well 1 8 too h gh, the playback sound may be greatly dotoned. Since dgdauy recorded CDs rave a large dynainic range (the \time can vary tremendously born very soft to extremely loud), do net set the recording lean any higher than s necessary. Precautions when recording: • Do not rer or bump the main unit writer recording Otherwise, the recording may be unusable • Depending on toe strength era type or playback signal in be original recording, the new recording may not begin or pause at the cared point when in the syrrehro mode. If this happens, IN making a manual recording. Precautions when Inserting a Mini- • To insect a MiniDisc, push on the middle of the edge of the disc whilst holding paralle to the man unit. • If any resiatance is tell, do not try l0 tome toe MiniDbc into 0e unit. It may cause 1701e problems. It resistance is fell remove the MiniDisc and try reloadingR. Note: • Whenever ary button is pressed, the remote control display we ight for about seconds. E-11