Sharp MX-2615N Operating Guide - Page 558
Touch the desired erase mode., Set the erasure width with the, keys., Touch the [OK] key.
View all Sharp MX-2615N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 558 highlights
SCANNER/INTERNET FAX (1) Scan/Special Modes Erase Edge Erase Center Erase Edge+Center Erase Side Erase (2) (3) OK Cancel OK Edge 1/2 (0 1) inch 4 Select the erase settings. (1) Touch the desired erase mode. Select one of the 4 erase modes. Touch the [Side Erase] key to open the following screen. Erase Side Erase Up Cancel OK Erase position for Original Side 2 Left Right Down Same Side as Side 1 Different Side from Side 1 Touch the checkbox of the edge that you wish to erase and make sure that a checkmark ( ) appears. When performing two-sided scanning, set the erase edge on the reverse side. • If you touch the [Same Side as Side 1] key, the edge in the same position as on the front side will be erased. • If you touch the [Different Side from Side 1], the edge in the position opposite to the erased edge on the front side will be erased. When you have completed the settings, touch the [OK] key. (2) Set the erasure width with the keys. 0" to 1" (0 mm to 20 mm) can be entered. (3) Touch the [OK] key. Press the [COLOR START] key or the [BLACK & WHITE START] key. Scanning begins. • If you inserted the original pages in the document feeder tray, all pages are scanned. A beep will sound to indicate that scanning is finished. • If you are scanning the original on the document glass, scan each page one page at a time. When scanning of one page finishes, replace it with the next page and press the [COLOR START] key or the [BLACK & 5 WHITE START] key. Repeat until all pages have been scanned and then press the [Read-End] key. A beep will sound to indicate that scanning is finished. If the destination is an Internet fax destination, press the [BLACK & WHITE START] key. To cancel scanning... Press the [STOP] key ( ) to cancel the operation. When the erase function is used, erase takes place at the edges of the original image. If you also use a reduction or an enlargement setting, the erase width will change according to the selected ratio. For example, if the erase width setting is 1" (20 mm) and the image is reduced to 50%, the erase width will be 1/2" (10 mm). To cancel the erase setting... Touch the [Cancel] key in the screen of step 4. System Settings (Administrator): Erase Width Adjustment The default erase width setting is linked to the copy mode system setting, and can be set from 0" to 1" (0 mm to 20 mm). The factory default setting is 1/2" (10 mm). 5-76 Contents