Sharp MX-2615N Operating Guide - Page 735
Device Control
View all Sharp MX-2615N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 735 highlights
SYSTEM SETTINGS Device Control These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings. Other Settings Original Feeding Mode The following original feeding modes can be set to operate by default in copy, Scan to HDD, and image send modes. When a mode is frequently used, this saves you from having to select the mode in the special modes each time you need to use it. • Mixed Size Original (Same Width (Copy mode only)/Different Width) • Slow Scan Mode • Blank Page Skip (image send*) * Excluding fax mode and Internet fax mode. Auto Paper Selection Setting The paper types* that the Auto Paper Selection function will select can be specified. Select one of the following settings: • Plain Paper • Plain and Recycle Paper • Recycle Paper The Auto Paper Selection function will not select any paper types other than the paper types specified with this setting. * The paper type set for each paper tray using "Paper Tray Settings" (page 7-13) in the system settings (general). Tandem Connection Setting When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number and IP address of the machine used as the tandem slave machine. Disabling of Master Machine Mode To prohibit tandem transmission, enable this setting. (There is normally no need to enable this setting.) Disabling of Slave Machine Mode To prohibit tandem reception, enable this setting. (There is normally no need to enable this setting.) • The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change the port number. • To use the tandem function when user authentication is enabled, the same login name and password must be used on both the master machine and slave machine. If the same login name and password are not used, the page count may not be added to the appropriate user count or only the master machine may print. Detect Standard in Auto Color Mode When the color mode is set to auto in copy mode, the discrimination point for detecting whether originals are color or black and white can be set to one of 5 levels. To make it easier to detect a black and white original, adjust the setting toward [Black & White]. To make it easier to detect a color original, adjust the setting toward [Color]. Registration Adjustment If the colors are out of place on the printed surface when color printing is performed, the print positions of the colors can be adjusted. To perform this adjustment, touch the [Auto Adjustment] key. A message will appear. Touch the [Execute] key. Optimization of a Hard Disk This function optimizes the hard drive of the machine by defragmenting data. If a job is in progress, a message will appear and optimization will not begin until the job is finished. During optimization, the following operations are not possible: • Web page access, reception of print data • Use of keys on the operation panel • Turning off the power with the main power switch of the machine. • Auto Power Shut-Off When optimization is completed, the machine will automatically restart. When the document filing function is frequently used and output of files seems somewhat slow, optimizing the hard drive may improve performance. Fusing Cleaning Mode Use this function to clean the machine's fusing unit when dots or other dirt appear on the printed side of the paper. When this function is executed, "V" printed paper is output and the fusing unit is cleaned. If improvement is not noticed after the first time you use the function, try executing the function again. 7-68 Contents