Sharp MX-M350N MX-M350U MX-M450U MX-M350N MX-M450N Operation Manual - Page 214
Saddle stitch position adjust, High speed stacking, Auto paper selection setting
![]() |
View all Sharp MX-M350N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
GENERAL SETTINGS Saddle stitch position adjust This setting is used to adjust the stapling position (folding position) when using the saddle stitch function of the optional saddle stitch finisher. The value can be adjusted in 0.1 mm increments within ±3.0 mm from the reference position for each paper size. Max.+3mm Position adjusted to the plus direction Min.-3mm Position adjusted to the minus direction 1 2 12 11 Reference position [AUTOMATIC SADDLE STITCH] checkmark The saddle stitch print function can normally be divided into the following three general steps. 1. The pages of the original are automatically reordered to allow saddle stitch binding (saddle stitch function). 2. The pages are folded at the center. 3. The paper is stapled at the center in two places (saddle stitch stapling). The [AUTOMATIC SADDLE STITCH] checkbox is selected by default. Selection of the checkbox assumes the use of the above saddle stitch printing function (three steps). Saddle stitch stapling exceptions Depending on the purpose of saddle stitch stapling, it may be necessary to perform saddle stitch stapling on printed matter that has already been bound by saddle stitching. In this case, it is necessary to disable step 1 above. If you frequently perform this type of exceptional saddle stitch stapling that requires disabling step 1, remove the checkmark from the [AUTOMATIC SADDLE STITCH] checkbox. High speed stacking This setting is used to give priority to print speed when printing in offset mode with the saddle stitch finisher installed. When priority is given to print speed, a slight decrease in stacking performance may occur. This setting is enabled by factory default. Auto paper selection setting Use this setting to select the paper type* for which the automatic paper selection function operates. Selections are "PLAIN PAPER", "PLAIN AND RECYCLE PAPER", and "RECYCLE PAPER". * The paper type set for each paper tray in the paper tray settings of the system settings (page 2-5 of the "Operation manual (for general information and copier operation)"). 12 Optimization of a hard disk This is used to optimize the "Main folder" and "Custom folder" that are used for the document filing function. When this setting is executed, a message will appear asking if it is okay to stop the job in progress. Touch the [YES] key to stop the job and begin optimization. When optimization ends, the machine will restart if the power switch is switched on, or turn off if the power switch is switched off. CAUTION If the power switch is switched off or the power plug is unplugged while optimization is in progress, the hard drive may be damaged and stored data or received data may be lost. NOTES ● About stopped jobs Printing of received faxes and Internet-Faxes and transmission of stored fax jobs will automatically resume after the machine restarts. For jobs other than the above (copy jobs, print jobs, document filing print jobs, etc.), the job information is not retained and thus the stopped job must be executed again manually (for example, the original for a copy job must be placed again and the copy operation repeated). ● Operation after optimization starts Until optimization finishes (or the [CANCEL] key is touched to cancel optimization), • The operation panel cannot be used, with the exception of the [CANCEL] key. • Operation from the Web page is not possible. • Faxes and Internet-Faxes cannot be received. • Print jobs will not be accepted. • The power will not turn off even if the power switch is switched off. • Auto power shut-off mode will not activate even if the set time elapses. (Preheat mode will activate.)
![](/manual_guide/products/sharp-mx450u-mxm350u-mxm450u-mxm350n-mxm450n-operation-manual-9522b59/214.png)