Sharp MX-M623 MX-M623 MX-M753 Operation Manual - Page 97

BEFORE USING THE MACHINE FINISHER (3 TRAYS) The finisher (3 trays) is equipped with the offset function, which offsets each set of output from the previous set, and the staple sort function, which staples each set of output. A punch module can also be installed to punch holes in output. PART NAMES (1) (2) (4) (3) (5) (1) Stapler compiler This temporarily stacks paper to be stapled. (2) Middle tray Open this cover to remove paper jams in the stapler compiler. (3) Output trays (upper tray, middle tray*, lower tray) Stapled and offset output is delivered to these trays. The trays are slidable. For large-size output (11" x 17", 8-1/2" x 14", 8-1/2" x 13", 8-1/2" x 13-1/2", 8-1/2" x 13-2/5", A3, B4 and 8K sizes), extend the tray. (4) Right front cover Open this cover to remove a paper misfeed. (5) Left front cover Open this cover to replace the staple cartridge or remove a staple jam. * Stapled and offset copies cannot be delivered to the middle tray. • Do not place heavy objects on the finisher (3 trays) or press down on the finisher (3 trays). • Use caution when you turn on the power and when printing is taking place, as the output tray may move up and down. • A finisher (3 trays) cannot be installed simultaneously with a saddle stitch finisher or a finisher. SUPPLIES The finisher (3 trays) require the following staple cartridge: Staple cartridge (approx. 5000 staples x 3 cartridges) MX-SC10 1-56 Contents