Sharp PG-A10S-SL Operation Manual - Page 25
Setup
UPC - 074000358966
View all Sharp PG-A10S-SL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Setup Using the Adjustment Feet The height of the projector can be adjusted using the adjustment feet at the front and rear of the projector when the surface the projector is placed on is uneven or when the screen is slanted. The projection of the image can be made higher by adjusting the projector when it is in a lower place than the screen. 1 While pressing the foot releases on both sides, lift the projector to adjust its height and then remove your fingers from the foot releases. 2 Rotate the adjustment feet at the front of the projector for fine adjustment. • You can adjust the projection by using the rear adjustment foot on the bottom of the projector when the projector is positioned at the higher place than the screen. Note • When returning the projector to its original position, hold the projector firmly, press the foot releases and then gently lower it. • The projector is adjustable up to approximately 12 degrees at the front and 3 degrees at the back from the standard position. Info • Do not press the foot releases when the adjustment feet are extended without firmly holding the projector. • Do not hold the lens when lifting or lowering the projector. • When lowering the projector, be careful not to get your fingers caught in the area between the adjustment foot and the projector. A10X_A10S#E_Print#p21_25.p65 21 Downloaded from www.Manualslib.com manuals search engine Rear adjustment foot (on the bottom) Foot release (on the other side of the projector as well) Front adjustment feet 21 03.2.4, 2:02 PM Connections and Setup