Sharp PG-A10S-SL Operation Manual - Page 31
Basic Operation
UPC - 074000358966
View all Sharp PG-A10S-SL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Basic Operation 3 Press , or on the remote control to select the IN- PUT mode. • After pressing once on the projector, use to select the desired input mode. "On-screen Display (Example) INPUT 1 mode Using RGB ➝ ➝ ➝ Note • When no signal is received, "NO SIGNAL" will be displayed. When a signal that the projector is not preset to receive is received, "NOT REG." will be displayed. • The INPUT mode is not displayed when "OSD Display" is set to "OFF". (See page 44.) About the INPUT mode INPUT 1 Used for projecting im- (RGB/ ages from equipment that Component) sends RGB signals or component signals con- nected to the RGB input terminal. INPUT 2 Used for projecting im(S-Video) ages from equipment connected to the SVIDEO input terminal. INPUT 3 Used for projecting im(Video) ages from equipment connected to the VIDEO input terminal. 4 Press or on the remote control to adjust the volume. Using Component INPUT 2 mode Using S-Video INPUT 3 mode Using Video Note • Pressing will lower the volume. Pressing will raise the volume. • On the projector, the volume can be adjusted by pressing or . 5 Press on the remote con- trol to temporarily display a black screen and turn off the sound. Note • Pressing again will turn the pro- jected image and sound back on. 27 A10X_A10S#E_Print#p26_31.p65 27 03.2.4, 2:04 PM Downloaded from www.Manualslib.com manuals search engine