Sharp XG-P10XU XGP10XU Operation Manual - Page 14

Setup & Connections Connecting the Projector Connecting the Projector to Video Equipment You can connect your projector to a VCR, laser disc player, DVD player, DTV decoder and other audiovisual equipment. CAUTION • Always turn off the projector while connecting to video equipment, in order to protect both the projector and the equipment being connected. Connecting a VCR, laser disc player and other audiovisual equipment using the standard video Input 1 Connect the yellow RCA connectors to the corresponding yellow VIDEO INPUT 3 terminal on the projector and the Video output terminal on the video source. 2 To use the built-in audio system, connect the red and white RCA connectors to the corresponding red and white AUDIO INPUT 3 terminals on the projector and the Audio output terminals on the video source. The S-VIDEO INPUT terminal uses a video signal system in which the picture is separated into a color and a luminance signal to realize a higher-quality image. When cables are connected to both the S-VIDEO INPUT and VIDEO INPUT 3 terminals, images input through the S-VIDEO INPUT terminal have priority over images input through the VIDEO INPUT 3 terminal. • For higher quality video, you may use the S-VIDEO INPUT terminal on the projector. S- video cable is sold separately. • If your video equipment does not have an S-video output terminal, use the Composite video output terminal. 2 1 2 Audio cable (sold separately) 3 L AUDIO R VIDEO MONITOR 1 Video cable (sold separately) To audio output terminals To video output terminal VCR or Laser disc player S-video cable (sold separately) To S-video output terminal Connecting a DVD player, DTV decoder and other component video equipment using the 5 BNC Input 1 To use the 5 BNC connectors, slide the 15 pin/BNC switch on the rear terminals to the BNC position. Connect each BNC connector to the corresponding BNC INPUT 1 terminals on the projector. • BNC-RCA adaptors are included for use with RCA type cables and sources. 2 Connect the other end of the cable to the corresponding terminals of a DVD player or DTV decoder. 3 To use the built-in audio system, connect one end of an audio cable to the AUDIO INPUT 1 terminal on the projector. Connect the other end to the Audio output terminal on the video equipment. • A 3.5 mm minijack to RCA audio cable adaptor may be necessary. When connecting this projector to a DVD player or a DTV decoder, select "Component" for "Signal Type" on the GUI menu. (See page 27.) 3 To audio output terminals 1 2 Audio cable (sold separately) 3 L AUDIO R VIDEO MONITOR 2 To analog component output terminals DTV decoder or DVD player E-13 Three BNC-RCA adaptors QPLGJ0107GEZZ Component cable (sold separately)