Singer 20U-109 Instruction Manual - Page 29
regulating
View all Singer 20U-109 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Zigzag Sewing Machine Knee operating stitch width control: Bell cranks '1' and '2' shown in Figure 35 are fastened to the underside of the bed, Bell crank '1' is used for lifting and lowering the presser foot with knee and bell crank '2' is used for controlling the stitch width. To control the stitch width with knee, loosen screw '4' holding the knee lifter shaft arm '3' and move knee lifter shaft arm '3' just under the bell crank '2' and firmly tighten screw '4'. Loosen the lock nut holding screw '7' and turn screw '7' as required, so that the bent end '6' of knee lifter shaft arm '3' will be almost horizontal when knee lifter knee plate '5' is pushed as far as it will go in the direction indicated with arrow 'A'. Then firmly tighten the lock nut. With knee lifter shaft arm '3' set in position as described above, loosen screw '8' and move knee lifter shah arm '3' up or down as required, so that height '10' from its bent end '6' to bracket is 67 mm. Loosen stitch width regulating plate thumb screws '11' and '12' so that stitch width regulator '13' can be moved from zero to maximum stitch width. (20U-109 / 109C / 308: 9mm or 20U-112 / 112C: 12mm). Loosen the lock nut holding screw '14' and turn screw '14' as required, so that knee lifter knee plate '5' when pushed in the direction indicated with arrow 'B', will stop at the maximum stitch width position of stitch width regulator '13'. Then firmly tighten the lock nut. Stitch width will become wider when knee lifter knee plate '5' is pushed in the direction indicated with arrow 'B' and will become smaller when knee plate is released. Instruction Manual and Parts List 12 11 13 2 14 3 67 10 67 rnm Figure 35 Caution: • Switch off the machine. • Set sewing head upright again using both hands. • Danger of crushing between sewing head and table top