Singer One Instruction Manual 4 - Page 10
instructions
View all Singer One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Press Toe Upward for Removal I CHANGING PRESSER FEET o Snap-on Presser Feet Most of the presser feet furnished with your machine snap on and off a common shank. Center the Pin of New Presser Foot under Shank 1. Raise take-up lever to its highest position by turning the hand wheel toward you. 2. Raise presser foot. % 3. Press toe of presser foot upward (as far as it will go) and then snap down to remove. 4. Center the new presser foot under the shank and lower the presser-foot lifter so that the shank fits over the presser-foot pin. 5. Press presser-foot screw down until foot snaps into place. Lower Presser Bar and Press Down on Screw to Secure New Foot To remove and replace the shank of snap-on presser feet, follow instructions below for onepiece presser feet. O Changing Snap-on Presser Feet Presser Foot Screw Changing Button Foot 4 One-piece Presser Feet 1. Raise take-up lever to its highest position by turning the hand wheel toward you. 2. Raise presser foot. 3. Loosen presser foot screw and remove the foot guiding it to the right. The Button Foot • Hook button foot around the presser bar and tighten presser-foot screw.