Smeg BCC02RDMUS User manual - Page 14
If the LED 25
View all Smeg BCC02RDMUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Cleaning and maintenance If the LED (25) flashes, it means that a descaling cycle is mandatory to proceed with further dispensing of drinks. To carry out a descaling cycle, proceed as follows: • Place a container with a capacity of at least 1.4l under the dispenser (11) and the steam spout (30). • Make sure that the Primary program with white illuminated keys is selected. • Fill the tank (5), up to the "MAX" level, with a solution of water and descaler in the doses recommended by the manufacturer. • With the machine ready for use, press the keys (20) and (18) simultaneously for at least 3 seconds. The key (18) flashes with an orange light and the LED (25) has a fixed light for the entire duration of the descaling cycle, which has duration of several minutes. • The descaling cycle ends when the solution contained in the tank (5) is finished, the key (18) and the LEDs (21) and (25) light up fixed. • During the descaling cycle, the machine will take a few breaks to allow the descaler to act effectively. Wait for the end of the cycle. • Pour clean water into the tank (5) up to the "MAX" level to carry out the rinse cycle, then press the button (18) to start the rinse cycle, the button (18) flashes and the LED (25) lights up steadily for the entire duration of the washing cycle. • When the tank (5) is empty, the rinse cycle is finished. • The keys light up in white. If, at the end of the descaling process, the LED (25) remains permanently lit, it indicates that a new descaling cycle must be carried out since the quantity of descaling solution that was used was insufficient for complete cleaning. Any other servicing should be performed by an authorized service representative. "Empty system" procedure The 'Empty system' procedure is recommended before long periods of non-use and before consulting a maintenance manager. • Activate the procedure by holding down the key (16) and the key (19) simultaneously for three seconds, the key (17) and the key (19) flash simultaneously. • The entire quantity of water in the tank is drained through the coffee circuit and the steam spout. • The pump continues to operate, even intermittently, to also empty the internal water circuits. • At the end of the procedure the machine switches off. The empty system procedure takes several minutes and on-off cycles. Do not turn off the machine until the complete procedure is complete. EN - 14