Smeg CMSU6451X Instruction Manual 1 - Page 18
Cleaning the milk container, CHANGING AND SETTING MENU PARAMETERS
View all Smeg CMSU6451X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
2. Open the service door (A2) (fig. 14). 3. Remove the drip tray (A11) and grounds container (fig. 15). 4. Press the two red release buttons inwards and at the same time pull the infuser outwards (fig. 28). Important! Do not use washing up liquid to clean the infuser. It would remove the lubricant applied to the inside of the piston, causing the infuser to seize up and become unusable. Cleaning the milk container Important! Always clean the tubes inside the milk container (B) when you prepare milk. If there is still milk in the container, do not leave it out of the refrigerator for longer than strictly necessary. Clean the container each time you prepare milk as described in Note 3 in the section "Making cappuccino". 1. Turn the milk container lid clockwise then remove it. 2. Remove the milk spout and intake tube. 5. Soak the infuser in water for about 5 minutes, then rinse under the tap. 6. After cleaning, replace the infuser (A5) by sliding it onto Spout the internal support and pin at the bottom; Support Milk intake tube Groove Pin Frothed milk regulator then push the PUSH symbol fully in until it clicks into place. N.B.: If the infuser is difficult to insert, you must first adapt it to the right dimensions by pressing it forcefully from the bottom and top as shown in the figure. 7. Once inserted, make sure the two red buttons have snapped out. 8. Replace the drip tray (A11) and grounds container. 9. Close the service door (A2). Hole Hole 3. Remove the frothed milk regulator by pulling it outwards. 4. Wash all the components thoroughly with hot water and mild washing-up liquid. Make sure there are no milk residues left inside the holes and the groove on the fine end of the frothed milk regulator. 5. Check that the intake tube and spout are not clogged with milk residues. 6. Replace the frothed milk regulator, milk spout and intake tube. 7. Replace the milk container lid. CHANGING AND SETTING MENU PARAMETERS After turning the knob (C6) to the right or left and waiting for the appliance to be ready, you can use the internal menu to modify the following parameters and functions: • CLOCK • ON 7:30 • AUTO-START NO 17