Smeg CMSU6451X Instruction Manual 1 - Page 23

TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The coffee is not creamy enough . The cups were not preheated. The infuser has cooled down because 2/3 minutes have elapsed since the last coffee was made. Heat the cups by rinsing them in hot water or leaving them to rest for at least 20 minutes on the cup warmer tray. Before making coffee, heat the infuser by pressing the button (C4). The coffee is ground too coarsely. Wrong type of coffee Turn the grinding adjustment knob one click anticlockwise towards "1" while the coffee mill is in operation. Use a type of coffee for espresso coffee makers. The coffee is delivered too slowly or a The coffee is ground too finely. drop at a time. Turn the grinding adjustment knob one click clockwise towards the 7 while the coffee mill is in operation. Continue one click at a time until coffee delivery is satisfactory. The effect is only visible after delivering two coffees. The coffee is delivered too quickly. The coffee is ground too coarsely. Turn the grinding adjustment knob one click anticlockwise towards "1" while the coffee mill is in operation. Avoid turning the grinding adjustment knob excessively otherwise when you select 2 cups, the coffee may be delivered a drop at a time. The effect is only visible after delivering two coffees. Coffee does not come out of one of the The spouts are blocked. spouts. Clean the spouts with a toothpick (fig. 26). The coffee does not come out of the spouts, but from around the service door (A2). The holes in the spouts are clogged with dry coffee dust. The coffee guide (A3) inside the service door is blocked and cannot swing. If necessary, remove coffee deposits with a toothpick, sponge or stiff bristled kitchen brush. Thoroughly clean the coffee guide (A3), particularly near the hinges. Water comes out of the spouts instead of The pre-ground coffee may be blocked in Clean the funnel (A17) with a wooden coffee. the funnel (A17). or plastic fork, clean the inside of the appliance. The milk does not come out of the milk The intake tube is not inserted or is in- Insert the intake tube (B4) in the rubber spout (B5). serted incorrectly. washer in the milk container lid (fig. 20). The milk is not well frothed. The milk container lid is dirty. The frothed milk regulator is not positioned correctly. Clean the milk container lid as described in the section"Cleaning the milk container". Adjust following the instructions in the section "Making cappuccino". 22