Smeg CMSU6451X Instruction Manual 1 - Page 20

• Press the OK button (C5) and refill the water tank with clean water. • The descale programme is now terminated and the appliance is ready to make coffee again. NOTE: If descaling is interrupted before completion, the machine still displays the descaling message and the process must be begun again from the beginning. Empty the water tank, rinse with clean water and deliver a cup of hot water. Important! FAILURETO DESCALETHE APPLIANCE REGULARLY INVALIDATES THE GUARANTEE. Changing coffee temperature To change coffee temperature, proceed as follows: • press the MENU button (C2) (the light over the button comes on) then press the NEXT button (C3) repeatedly until the appliance displays "TEMPERATURE HIGH..."; • press the CHANGE button (C4) until the appliance displays the required coffee temperature; • press the OK button (C5) to confirm the temperature selected; • Press the MENU button (C2) to exit programming mode or NEXT (C3) to change other parameters. Changing the length of time the appliance remains on The appliance is set by default to go off automatically 30 minutes after the last coffee has been made. To change this interval (max. 120 min), proceed as follows: • Press the MENU button (C2) (the light over the button comes on) then press the NEXT button (C3) repeatedly until the appliance displays "OFF AFTER..." • Press the CHANGE button (C4) to change the number of hours the appliance remains on. • Press the OK button (C5) to confirm. • Press the MENU button (C2) to exit programming mode or NEXT (C3) to change other parameters. from its packaging then dip it fully in the water for a few seconds, Then remove and wait about 30 seconds (until it changes colour and forms red squares). • switch the machine on by turning the knob (C6) to the right or left (fig. 6); • press the MENU button (C2) then press the NEXT button (C3) repeatedly until the appliance displays "WATER HARDNESS 4"; • press the CHANGE button (C4) repeatedly until the number coincides with the number of red squares on the test strip (for example, if there are 3 red squares on the test strip, press the button until "WATER HARDNESS 3" is displayed). • press the OK button (C5) to confirm. The coffee maker is now programmed to provide the descale warning when necessary based on the actual hardness of the water. Resetting default values (reset) If you change the original values, the default values can be reset as follows: • Press the MENU button (C2) then press the NEXT button (C3) repeatedly until the appliance displays "RESET TO DEFAULT NO"; • press the CHANGE button (C4) and the appliance displays "RESET TO DEFAULT YES"; • press the OK button (C5) to reset the default values; • The appliance is now reset to the default settings and the "READY" message is displayed. Washing procedure This function is available to customer services personnel only. CHANGING THE LANGUAGE To change the language, press the CHANGE button (C4) for at least 5 seconds until the appliance displays the installation message in various languages. Select the required language as described in the section "Using the appliance for the first time". Setting water hardness The descale message is displayed after the appliance has been operated for a factory set period of time calculated on the basis of the maximum quantity of limescale which may be contained in the water used. The operating period can be extended if required, making descaling less frequent by programming the machine on the basis of the real lime content in the water used. Proceed as follows: • remove the "Total Hardness Test" strip (attached to page 2) TURNING THE APPLIANCE OFF Each time the appliance is turned off, it performs an automatic rinse cycle which cannot be interrupted. Danger of burns! During rinsing, a little hot water flows from the coffee spouts. Avoid contact with splashes of water. To turn the appliance off, turn the knob (C6). The appliance performs the rinse cycle then goes off. 19