Smeg FAB32UCRLN User Guide - Page 26

Installation • To allow proper cooling of the condenser, the refrigerator must not be placed too close to the wall. To prevent this, the appliance comes complete with two plastic spacers which must be fitted to the top of the condenser. 5.3 Electrical connection Power voltage Danger of electrocution • The appliance must be connected to earth in compliance with electrical system safety standards. • Do not pull the cable to remove the plug. Positioning Place the appliance on a stable and level floor. If the floor is not perfectly level, use the two adjustable feet on the front part of the appliance. The appliance has two small wheels on the back to allow it to be moved and positioned more easily. In any case, we recommend moving the appliance very carefully in order to avoid damaging the floor (especially in the case of wooden floors). General information • Check the grid characteristics against the data indicated on the plate. The identification plate bearing the technical data, serial number and brand name is visibly positioned inside the appliance. Do not remove this plate for any reason. • Make sure that the plug and socket are of the same type. • Avoid using adapters and shunts as these could cause overheating and a risk of burns. • The plug must always be accessible when the appliance is installed. • Leave the refrigerator standing vertically for at least two hours before turning it on for the first time. • If it is necessary to replace the power cable, this must be performed by an authorised technician from Technical Support Service. 28