Smeg KSM24XU Instruction Manual - Page 8
Installation - head
View all Smeg KSM24XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALLATION Wall drilling and bracket fixing ÷1/16" 7.2.1 X 11 4"9/16 4"9/16 12a 12"5/8 24" Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the center of the area in which the hood will be installed. • Draw a horizontal line at 24" above the hob. • Place bracket 7.2.1 on the wall as shown about 1/16" from the ceiling or upper limit aligning the center (notch) with the vertical reference line. • Mark the wall at the centers of the holes in the bracket. • Place bracket 7.2.1 on the wall as shown at X" below the first bracket (X = height of the up- per chimney section supplied), aligning the center (notch) with the vertical line. • Mark the wall at the centers of the holes in the bracket. • Mark a reference point as indicated at 4" 9/16 from the vertical reference line and 13" 3/8 above the horizontal reference line. • Repeat this operation on the other side. • Drill ø 5/16" holes at all the center points marked. • Insert the wall plugs 11 in the holes. • Fix the brackets using the 12a screws supplied. • Insert the two screws 12a supplied in the hood body fixing holes, leaving a gap of 3/16 " between the wall and the head of the screw. EN 8 8