Smeg STU8222 User manual - Page 55

If after following the above troubleshooting instructions the problem, persists, call the nearest

Page 55 highlights

User instructions Food residues on the dishes White film in the chamber or on the door Dishes too close together, baskets too full The spray arms do not rotate Clogged spray arm nozzles Dirty filters Filters inserted incorrectly or not fastened in place Wash program unsuitable for the type of soil Combined detergent used with programs that are too short Not enough detergent (if you are using a powder detergent) Upper basket not horizontal The substances contained in the detergent has settled out Incorrect water hardness setting (too low or too high) Salt container cap not tightened (saline solution mixing with the wash water) Combined detergent or bio/eco detergent not very effective There must always be enough space between the dishes to allow water jets to pass. Avoid contact points Take care not to prevent the spray arms from rotating when loading the dishwasher Clean the spray arms as indicated in the manual Clean the filters as indicated in the manual Check and correct Find the suitable washing program in the program table Use a powder detergent or a more intensive program Increase the amount of detergent used The left and right sides of the upper basket must be at the same level Use a dishwasher cleaner Wash the appliance by hand Change detergent Adjust the water softener setting Change detergent Tighten the salt container cap properly Adjust the water softener system Use separate products If after following the above troubleshooting instructions the problem persists, call the nearest After-Sales Centre. WARNING: any operations performed on the appliance by unauthorised persons are not covered by the warranty and shall be paid for by the user. 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57

User instructions
55
Food residues on the dishes
Dishes too close together,
baskets too full
There must always be enough
space between the dishes to
allow water jets to pass. Avoid
contact points
The spray arms do not rotate
Take care not to prevent the
spray arms from rotating when
loading the dishwasher
Clogged spray arm nozzles
Clean the spray arms as
indicated in the manual
Dirty filters
Clean the filters as indicated in
the manual
Filters inserted incorrectly or
not fastened in place
Check and correct
Wash program unsuitable for
the type of soil
Find the suitable washing
program in the program table
Combined detergent used with
programs that are too short
Use a powder detergent or a
more intensive program
Not enough detergent (if you
are using a powder detergent)
Increase the amount of
detergent used
Upper basket not horizontal
The left and right sides of the
upper basket must be at the
same level
White film in the chamber or
on the door
The substances contained in
the detergent has settled out
Use a dishwasher cleaner
Wash the appliance by hand
Change detergent
Incorrect water hardness
setting (too low or too high)
Adjust the water softener
setting
Change detergent
Salt container cap not
tightened (saline solution
mixing with the wash water)
Tighten the salt container cap
properly
Combined detergent or bio/eco
detergent not very effective
Adjust the water softener
system
Use separate products
If after following the above troubleshooting instructions the problem
persists, call the nearest After-Sales Centre.
WARNING:
any
operations
performed
on
the
appliance
by
unauthorised persons are not covered by the warranty and shall be
paid for by the user.