Sony Ericsson W710i User Guide - Page 26

Tips when recording and using voice commands If your phone cannot detect your voice command, one of the following might have happened: • You spoke too softly - try speaking louder. • You held the phone too far away - hold it as you do during a call. • The voice command was too short - it should be around one second long and more than one syllable. • You spoke too late or too soon - speak immediately after the tone. • You did not record the voice command when the hands-free was attached - for voice control with a hands-free kit, record when the hands-free is attached. • You used another intonation - use the same intonation as in the recorded voice command. To activate voice dialling and record names Record names using the phone, portable hands-free, or Bluetooth™ hands-free. 1 } Settings } the General tab } Voice control } Voice dialling } Activate } Yes } New voice and select a contact. 2 If the contact has more than one number, use and to view the numbers. Select the number to add the voice command to. Record a voice command such as "John mobile". 3 Instructions appear. Wait for the tone and say the command to record. The voice command is played back to you, if the recording quality is acceptable. 4 If the recording sounds OK to you } Yes. If not } No and repeat step 3. To record another voice command for a contact } New voice } Add again and repeat steps 2-4 above. Caller name Hear your recorded contact name when you receive a call from that contact. To turn the caller name on or off } Settings } the General tab } Voice control } Play caller name. Voice dialling Start voice dialling from stand-by using the phone, a portable handsfree, a Bluetooth headset or by saying your magic word. 26 Calling This is the Internet version of the user's guide. © Print only for private use.