Sony CDP-CX400 Operating Instructions - Page 35

Troubleshooting, Specifications - parts

Page 35 highlights

Additional Information Troubleshooting If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There's no sound. , Check that the player is connected securely. , Make sure you operate the amplifier correctly. The CD does not play. , There's no CD inside the player ("-NO DISC-" appears). Insert a CD. , Insert the CD with the label side facing right. , CleantheCD(seepage34). , Moisturehascondensedinsidetheplayer. Remove the disc and leave the player turned on for about an hour (see page 34). The remote does not function. , Remove obstacles in the path of the remote and the player. , Point the remote at the remote sensor on the player. , Be sure to set up the remote correctly. , Replace all the batteries in the remote with new ones if they are weak. , Set the command mode of the remote according to the command mode of the player. The player functions incorrectly. , Themicrocomputerchipsmaybeoperating incorrectly. Disconnect the AC power cord, then connect it back to the wall outlet to reset the player. Specifications Compact disc player Laser Laser output Frequency response Dynamic range Harmonic distortion Semiconductor laser (λ = 780 nm) Emission duration: continuous Max 44.6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up block with 7 mm aperture. 2 Hz to 20 kHz ±0.5 dB More than 93 dB Less than 0.0045% Output Jack Maximum Load type output impedance level LINE OUT Phono jacks 2 V Over 10 kilohms (at 50 kilohms) DIGITAL OUT Optical -18 dBm (OPTICAL) output connector Wave length: 660 nm General Power requirements Power consumption Dimensions (approx.) (w/h/d) Mass (approx.) 120 V AC, 60 Hz 16 W 430 × 189 × 537 mm (17 × 7 1/2 × 21 1/4 in.) incl. projecting parts 8.8 kg (19 lbs 7 oz.) Supplied accessories See page 4. Design and specifications are subject to change without notice. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

35
Additional Information
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
*
This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ±0.5 dB
Dynamic range
More than 93 dB
Harmonic distortion
Less than 0.0045%
Output
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There
s no sound.
,
Check that the player is connected securely.
,
Make sure you operate the amplifier correctly.
The CD does not play.
,
There
s no CD inside the player (
“–
NO DISC
–”
appears). Insert a CD.
,
Insert the CD with the label side facing right.
,
Clean the CD (see page 34).
,
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 34).
The remote does not function.
,
Remove obstacles in the path of the remote and
the player.
,
Point the remote at the remote sensor
on the
player.
,
Be sure to set up the remote correctly.
,
Replace all the batteries in the remote with new
ones if they are weak.
,
Set the command mode of the remote according
to the command mode of the player.
The player functions incorrectly.
,
The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
LINE OUT
DIGITAL OUT
(OPTICAL)
Jack
type
Phono
jacks
Optical
output
connector
Maximum
output
level
2 V
(at 50 kilohms)
18 dBm
Load
impedance
Over 10 kilohms
Wave length: 660 nm
General
Power requirements
120 V AC, 60 Hz
Power consumption
16 W
Dimensions (approx.)
430
×
189
×
537 mm
(w/h/d)
(17
×
7 1/2
×
21 1/4 in.) incl. projecting
parts
Mass (approx.)
8.8 kg (19 lbs 7 oz.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.