Sony CDX-F5000 Operating Instructions (primary manual) - Page 17

Adjusting the sound characteristics, Quickly attenuating the sound

Get Sony CDX-F5000 - Fm/am Compact Disc Player PDF manuals and user guides View all Sony CDX-F5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

When an MP3 file is played, you can select an album using the rotary commander. (With optional unit) To Do this Skip discs - Disc selection Push in and rotate [once for each disc] the control. To continuously skip discs, push in and rotate once and rotate again within 2 seconds (and hold) the control. Skip albums*3 1 To enter Album selection - Album selection mode, push in, then rotate and hold the control. Within 2 seconds, proceed to step 2. 2 Push in, then rotate quickly and repeatedly, to skip albums one by one. *1 Only if the corresponding optional equipment is connected. *2 If your car has no ACC (accessory) position on the ignition key switch, after turning off the ignition, be sure to press and hold (OFF) until the display disappears. *3 Available only when an optional CD unit with the MP3 file control function is connected, and MP3 file is played. Changing the operative direction The operative direction of controls is factory-set as shown below. To increase To decrease If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction. Adjusting the sound characteristics You can adjust the balance, fader, low pass filter and subwoofer volume. 1 Press the select button repeatedly until "BAL," "FAD," "LPF" or "SUB" appears. Each time you press the select button, the item changes as follows: LOW*1 t MID*1 t HI*1 t BAL (left-right) t FAD (front-rear) t LPF (low pass filter)*2*3 t SUB (subwoofer volume)*2*4 *1 When EQ3 is activated (page 19). *2 When "SUB" is selected (page 18). *3 The cut off frequency is adjustable to 78 Hz, 125 Hz or OFF. *4 The volume level is adjustable between -10 and +10 steps. (Below -10, "ATT" is displayed.) 2 Rotate the volume control dial to adjust the selected item. Note Adjust within 3 seconds after selecting the item. Quickly attenuating the sound (With the rotary commander or the card remote commander) Press (ATT). After "ATT-ON" momentarily appears, "ATT" appears in the display. To restore the previous volume level, press (ATT) again. Tip When the interface cable of a car telephone is connected to the ATT lead, the unit decreases the volume automatically when a telephone call comes in (Telephone ATT function). Press (SEL) for 2 seconds while pushing the VOL control. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
17
When an MP3 file is played, you can select an
album using the rotary commander.
(With optional unit)
*1
Only if the corresponding optional equipment is
connected.
*2
If your car has no ACC (accessory) position on the
ignition key switch, after turning off the ignition, be
sure to press and hold
(OFF)
until the display
disappears.
*3
Available only when an optional CD unit with the
MP3 file control function is connected, and MP3 file
is played.
Changing the operative direction
The operative direction of controls is factory-set
as shown below.
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press
(SEL)
for 2 seconds while
pushing the VOL control.
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press the select button repeatedly
until “BAL,” “FAD,” “LPF” or “SUB”
appears.
Each time you press the select button, the
item changes as follows:
LOW
*
1
t
MID
*
1
t
HI
*
1
t
BAL (left-right)
t
FAD (front-rear)
t
LPF (low pass filter)
*
2
*
3
t
SUB (subwoofer volume)
*
2
*
4
*1
When EQ3 is activated (page 19).
*2
When “SUB” is selected (page 18).
*3
The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4
The volume level is adjustable between –10
and +10 steps. (Below –10, “ATT” is displayed.)
2
Rotate the volume control dial to
adjust the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press
(ATT)
.
After “ATT-ON” momentarily appears,
“ATT” appears in the display.
To restore the previous volume level, press
(ATT)
again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
To
Do this
Skip discs
– Disc selection
Push in and rotate [once for
each disc] the control.
To continuously skip discs,
push in and rotate once and
rotate again within 2
seconds (and hold) the
control.
Skip albums*
3
– Album selection
1
To enter Album selection
mode, push in, then rotate
and hold the control.
Within 2 seconds,
proceed to step
2
.
2
Push in, then rotate
quickly and repeatedly, to
skip albums one by one.
To increase
To decrease