Sony CDX-F5000 Operating Instructions (primary manual) - Page 24

Error displays/Messages - car stereo

Page 24 highlights

Radio reception Preset tuning is not possible. • Store the correct frequency in the memory. • The broadcast signal is too weak. The stations cannot be received. The sound is hampered by noises. • Connect a power antenna control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's antenna booster (only when your car has built-in FM/AM antenna in the rear/side glass). • Check the connection of the car antenna. • The auto antenna will not go up. t Check the connection of the power antenna control lead. • Check the frequency. • When the DSO mode is on, the sound is sometimes hampered by noises. t Set the DSO mode to "OFF" (page 20). Automatic tuning is not possible. • The local seek mode is set to "ON." t Set the local seek mode to "OFF" (page 14). • The broadcast signal is too weak. t Perform manual tuning. The "ST" indication flashes. • Tune in the frequency accurately. • The broadcast signal is too weak. t Set the monaural reception mode to "ON" (page 15). A program broadcast in stereo is heard in monaural. The unit is in monaural reception mode. t Cancel monaural reception mode (page 15). 24 Error displays/Messages Error displays (For this unit and optional CD/MD changers) The following indications will flash for about 5 seconds, and an alarm sound will be heard. BLANK*1 No tracks have been recorded on an MD.*2 t Play an MD with recorded tracks on it. ERROR*1 • A CD is dirty or inserted upside down.*2 t Clean or insert the CD correctly. • A CD/MD cannot play because of some problem. t Insert another CD/MD. FAILURE (Illuminates until any button is pressed.) The connection of speakers/amplifiers is incorrect. t See the installation guide manual of this model to check the connection. FAILURE (Illuminates for about 1 second.) When the XM tuner is connected, storing an XM radio channel into a preset failed. t Be sure to receive the channel that you want to store, then try it again. NO DISC No disc is inserted in the CD/MD unit. t Insert discs in the CD/MD unit. NO MAG The disc magazine is not inserted in the CD unit. t Insert the magazine in the CD unit. NO MUSIC A CD which is not a music file is inserted in the MP3 playable CD unit. t Insert a music CD in the MP3 playable CD unit. NOTREADY The lid of the MD unit is open or the MDs are not inserted properly. t Close the lid or insert the MDs properly. OFFSET There may be an internal malfunction. t Check the connection. If the error indication remains on in the display, consult your nearest Sony dealer. RESET The CD/MD unit cannot be operated because of some problem. t Press the RESET button on the unit. *1 When an error occurs during playback of a CD or MD, the disc number of the CD or MD does not appear in the display. *2 The disc number of the disc causing the error appears in the display.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

24
Error displays/Messages
*1
When an error occurs during playback of a CD or
MD, the disc number of the CD or MD does not
appear in the display.
*2
The disc number of the disc causing the error
appears in the display.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster
(only when your car has built-in FM/AM
antenna in the rear/side glass).
• Check the connection of the car antenna.
• The auto antenna will not go up.
t
Check the connection of the power
antenna control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
t
Set the DSO mode to “OFF” (page 20).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
t
Set the local seek mode to “OFF”
(page 14).
• The broadcast signal is too weak.
t
Perform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set the monaural reception mode to
“ON” (page 15).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Cancel monaural reception mode
(page 15).
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
BLANK
*
1
No tracks have been recorded on an MD.*
2
t
Play an MD with recorded tracks on it.
ERROR
*
1
• A CD is dirty or inserted upside down.*
2
t
Clean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.
t
Insert another CD/MD.
FAILURE
(Illuminates until any button is
pressed.)
The connection of speakers/amplifiers is
incorrect.
t
See the installation guide manual of this
model to check the connection.
FAILURE
(Illuminates for about 1 second.)
When the XM tuner is connected, storing an
XM radio channel into a preset failed.
t
Be sure to receive the channel that you
want to store, then try it again.
NO DISC
No disc is inserted in the CD/MD unit.
t
Insert discs in the CD/MD unit.
NO MAG
The disc magazine is not inserted in the CD
unit.
t
Insert the magazine in the CD unit.
NO MUSIC
A CD which is not a music file is inserted in
the MP3 playable CD unit.
t
Insert a music CD in the MP3 playable CD
unit.
NOTREADY
The lid of the MD unit is open or the MDs are
not inserted properly.
t
Close the lid or insert the MDs properly.
OFFSET
There may be an internal malfunction.
t
Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
RESET
The CD/MD unit cannot be operated because
of some problem.
t
Press the RESET button on the unit.