Sony CDX-FW700 Operating Instructions - Page 29
Error displays/Messages - error message
View all Sony CDX-FW700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Radio reception Preset tuning is not possible. • Store the correct frequency in the memory. • The broadcast signal is too weak. The stations cannot be received. The sound is hampered by noises. • Connect a power antenna control lead (blue) or accessory power supply lead (red) to the power supply lead of the car's antenna booster. (Only if your car has a built-in FM/ AM antenna in the rear/side glass.) • Check the connection of the car antenna. • The auto antenna will not go up. t Check the connection of the power antenna control lead. • Check the frequency. • When the DSO mode is on, the sound is sometimes hampered by noises. t Set the DSO mode to "OFF" (page 23). Automatic tuning is not possible. • The local seek mode is set to "on." t Set the local seek mode to "off" (page 21). • The broadcast signal is too weak. t Perform manual tuning. The "ST" indication flashes. • Tune in the frequency accurately. • The broadcast signal is too weak. t Set to the monaural reception mode (page 21). A program broadcast in stereo is heard in monaural. The unit is in monaural reception mode. t Cancel monaural reception mode (page 21). Interference occurs during FM reception. The wide mode is selected. t Set the IF mode to "IF-Auto" (page 21). Error displays/Messages Error displays (For this unit and optional CD/MD changers) The following indications will flash for about 5 seconds, and an alarm sound will be heard. Blank*1 No tracks have been recorded on an MD*2. t Play an MD with recorded tracks on it. Error*1 • A CD is dirty or inserted upside down*2. t Clean or insert the CD correctly. • A CD/MD cannot play because of some problem*2. t Insert another CD/MD. Failure*3 (Illuminates until any button is pressed.) The connection of speakers/amplifiers is incorrect. t See the installation guide manual of this model to check the connection. FAILURE*3 (Illuminates for about 1 second.) When the XM tuner is connected, storing an XM radio channel into a preset failed. t Be sure to receive the channel that you want to store, then try it again. High Temp The ambient temperature is more than 50°C (122°F). t Wait until the temperature goes down below 50°C (122°F). NO Disc*1 No disc is inserted in the CD/MD unit. t Insert discs in the CD/MD unit. NO Magazine The disc magazine is not inserted in the CD unit. t Insert the magazine in the CD unit. NO Music*2 A CD which is not a music file is inserted in the MP3 playable CD unit. t Insert a music CD in the MP3 playable CD unit. Offset There may be an internal malfunction. t Check the connection. If the error indication remains on in the display, consult your nearest Sony dealer. Push Reset The CD/MD unit cannot be operated because of some problem. t Press the RESET button on the unit. *1 When the CD/MD changer is connected to the unit, the disc number of the CD or MD appears in the display. *2 The disc number of the disc causing the error appears in the display. *3 "Failure" (small case) and "FAILURE" (upper case) are different messages. If these solutions do not help improve the situation, consult your nearest Sony dealer. Messages Local Seek +/- The local seek mode is on during automatic tuning (page 16). " " or " " You have reached the beginning or the end of the disc and you cannot go any further. 29