Sony CMT-EP50 Operating Instructions - Page 9

CD Programing the CD tracks - Program Play You can make a program of up to 32 tracks in the order you want them to be played. 1 Press CD, then place a CD. 2 Press PLAY MODE (PLAY MODE/RDS/ DIR on the remote) repeatedly until "PROGRAM" appears in the display. 3 Press . m or M > until the desired track appears in the display. Preset number Using the CD display Press DISPLAY repeatedly. The display changes as follows: During normal play Elapsed playing time on the current track t Remaining time on the current track t Remaining time on the current CD t Clock display (for five seconds) t Elapsed playing time on the current track t ... In the stop mode Total number of tracks and total playing time t Clock display (for five seconds) t Total number of tracks and total playing time t ... Selected track number (including selected track) 4 Press ENTER (TUNER MEM/ENTER on the remote). The track is programed. The program step number appears. 5 To program additional tracks, repeat steps 3 to 4. 6 Press nN. Program Play starts. To Do this Cancel Program Press PLAY MODE (PLAY Play MODE/RDS/DIR on the remote) until "PROGRAM" disappears from the display. Add a track to the end of the program Do step 3 and 4 with Program Play stopped. Erase the entire Press x once, when Program Play program is in stop mode, or twice during Program Play. Tip The program you made remains in the system's memory even after it has been played back. Press CD, then press nN to play the same program again. 9