Sony CMT-MX700Ni Operating Instructions - Page 59
CD/MP3 player, Tuner, iPod/iPhone, The STANDBY indicator remains lit after
UPC - 027242786172
View all Sony CMT-MX700Ni manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Troubleshooting There is no sound. , Are the + and - speaker cords short-circuited? , Are you using only the supplied speakers? , Is anything blocking the ventilation holes of the system? , The specified station may have temporarily stopped broadcasting. Sound comes from only one channel, or the left and right volumes are not balanced. , Place the speakers as symmetrically as possible. , Connect only the supplied speakers. There is a severe hum or noise. , Move the system away from any sources of noise. , Connect the system to a different wall outlet. , Install a noise filter (not supplied) to the power cord. The remote does not function. , Remove any obstacles between the remote and the remote sensor on the unit, and position the unit away from fluorescent lights. , Point the remote at the sensor on the unit. , Move the remote closer to the system. , The batteries may be run down. Replace the batteries with new ones. The STANDBY indicator remains lit after unplugging the power cord. , The STANDBY indicator may not turn off immediately after unplugging the power cord. The indicator will turn off after about 40 seconds. This is not a malfunction. CD/MP3 player The sound skips, or the disc will not play. , Wipe the disc clean, and replace it. , Move the system to a location away from vibration (for example, to the top of a stable stand). , Move the speakers away from the system, or place them on separate stands. At high volume, speaker vibration may cause the sound to skip. Playback does not start from the first track. , Return to Normal Play by pressing PLAY MODE repeatedly until both "PGM" and "SHUF" disappear. Starting playback takes more time than usual. , The following discs can increase the time it takes to start playback: • a disc recorded with a complicated tree structure. • a disc recorded in multisession mode. • a disc that has not been finalized (a disc to which data can be added). • a disc that has many folders. Tuner There is a severe hum or noise, or stations cannot be received ("TUNED" or "ST" flashes on the display). , Connect the antenna properly. , Find a location and an orientation that provide good reception, and then set up the antenna again. , Keep the antennas away from the speaker cords and the power cord to avoid picking up noise. , Turn off nearby electrical equipment. The DAB/DAB+ radio station is not received properly (CMT-MX750Ni only). , Check all antenna connections, then perform the DAB Initial Scan procedure (see "Performing a DAB Initial Scan manually" (page 32)). , The current DAB/DAB+ service may not be available. Press +/- to select a different service. , If you have moved to another area, some services/ frequencies may have changed and you may not be able to tune into your usual broadcast. Perform the DAB Initial Scan procedure to re-register the contents of broadcasts. (Performing this procedure clears all previously stored presets.) iPod/iPhone There is no sound. , Make sure the iPod/iPhone is connected securely. , Make sure the iPod/iPhone is playing music. , Adjust the volume. The sound is distorted. , Make sure the iPod/iPhone is connected securely. , Turn down the volume. , Set the "EQ" setting of the iPod/iPhone to "Off" or "Flat." 59GB