Sony D-NE900 Operating Instructions (primary manual) - Page 32

Connecting a stereo system Notes • Before you play a CD, turn down the volume of the connected device to avoid damaging the connected speakers. • Use the AC power adaptor for recording. If you use the rechargeable battery or dry battery as a power source, the battery may become completely depleted during recording. • Adjust the volume properly on the connected device so that the sound will not be distorted. • This CD player uses the Serial Copy Management System, which allows only firstgeneration digital copies to be made. • When recording or playing an ATRAC CD/MP3 CD using a connected device, use only the analog connecting cord. • If you change the connected device, make sure to change the "AUDIO OUT" setting. When the headphones or other devices are connected to the i/LINE OUT (OPTICAL) jack When an optical digital connecting cord is connected, the output is automatically switched to an optical digital output. When a remote control or a connecting cord is connected, the current AUDIO OUT setting ("HP" or "LINE") flashes for about 5 seconds. If you connect another device to the i/LINE OUT (OPTICAL) jack, first remove the device and connect the headphones again, then switch the AUDIO OUT setting to "HP." When AUDIO OUT is set to "LINE" You cannot adjust the volume using VOL +/- on the CD player or the remote control. When using an optical digital connecting cord To record a CD on a MiniDisc, DAT, etc., make sure that the CD player is paused before starting the recording procedures. About the G-PROTECTION and equalizer functions when using the connecting cord or the optical digital connecting cord • To record high quality CD sound, set the G-PROTECTION setting to "G-PRO 1" on the menu. • If the AUDIO OUT setting is set to "LINE," the parametric equalizer function does not work. 32