Sony DAV-IS10/W Operating Instructions - Page 97

Notes about the Discs, Troubleshooting, Additional Information

Page 97 highlights

Notes about the Discs On handling discs • To keep the disc clean, handle the disc by its edge. Do not touch the surface. • Do not stick paper or tape on the disc. • Do not expose the disc to direct sunlight or heat sources such as hot air ducts, or leave it in a car parked in direct sunlight as the temperature may rise considerably inside the car. • After playing, store the disc in its case. On cleaning • Before playing, clean the disc with a cleaning cloth. Wipe the disc from the center out. • Do not use solvents such as benzine, thinner, commercially available cleaners, or anti-static spray intended for vinyl LPs. Troubleshooting If you experience any of the following difficulties while using the system, use this troubleshooting guide to help remedy the problem before requesting repairs. Should any problem persist, consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained. Power The power is not turned on. • Check that the AC power cord (mains lead) is connected securely. • Press "/1 after all indications disappear from the front panel display. • After connecting the AC power cord (mains lead), wait about 20 seconds before turning on the power by pressing "/1. If "PROTECTOR" and "PUSH POWER" appear alternately in the front panel display. Press "/1 to turn off the system, and check the following items after "STANDBY" disappears. • Are the 3 and # speaker cords short-circuited? • Are you using only the specified speakers? • Is anything blocking the ventilation slots of the system? Check the above items and fix any problems. After "STANDBY" disappears, wait about 20 seconds before turning on the power by pressing "/1. If the cause of the problem cannot be found even after checking all the above items, consult your nearest Sony dealer. Picture Additional Information There is no picture. • The video connecting cords are not connected securely. • The video connecting cords are damaged. • The control unit is not connected to the correct TV input jack (page 18, 22). • The video input on the TV is not set so that you can view pictures from the system. • You have set progressive format but your TV cannot accept the signal in progressive format. In this case, return the setting to interlace format (the default setting) (page 89). • Even if your TV is compatible with progressive format (525p) signals, the image may be affected when you set progressive format. In this case, continued 97US

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123

Additional Information
97
US
On handling discs
• To keep the disc clean, handle the disc by its
edge. Do not touch the surface.
• Do not stick paper or tape on the disc.
• Do not expose the disc to direct sunlight or
heat sources such as hot air ducts, or leave it in
a car parked in direct sunlight as the
temperature may rise considerably inside the
car.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning
cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners, or anti-static
spray intended for vinyl LPs.
If you experience any of the following
difficulties while using the system, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should any
problem persist, consult your nearest Sony
dealer.
Note that if service personnel changes some
parts during repair, these parts may be retained.
Power
The power is not turned on.
Check that the AC power cord (mains lead) is
connected securely.
• Press
"
/
1
after all indications disappear from the
front panel display.
After connecting the AC power cord (mains lead),
wait about 20 seconds before turning on the power
by pressing
"
/
1
.
If “PROTECTOR” and “PUSH POWER” appear
alternately in the front panel display.
Press
"
/
1
to turn off the system, and check the
following items after “STANDBY” disappears.
Are the
3
and
#
speaker cords short-circuited?
Are you using only the specified speakers?
Is anything blocking the ventilation slots of the
system?
Check the above items and fix any problems. After
“STANDBY” disappears, wait about 20 seconds
before turning on the power by pressing
"
/
1
. If the
cause of the problem cannot be found even after
checking all the above items, consult your nearest
Sony dealer.
Picture
There is no picture.
The video connecting cords are not connected
securely.
The video connecting cords are damaged.
The control unit is not connected to the correct TV
input jack (page 18, 22).
The video input on the TV is not set so that you
can view pictures from the system.
You have set progressive format but your TV
cannot accept the signal in progressive format. In
this case, return the setting to interlace format (the
default setting) (page 89).
Even if your TV is compatible with progressive
format (525p) signals, the image may be affected
when you set progressive format. In this case,
Notes about the Discs
Troubleshooting
continued