Sony DCR-PC350 Camera Operations Guide - Page 100
To set the [IR SETUP] code, Touch [IR TEST].
View all Sony DCR-PC350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
When connecting with an i.LINK cable Touch [i.LINK], then . Go on to "Step 2 : Adjusting the synchronization of the VCR" (p. 102). To set the [IR SETUP] code When you connect with an A/V connecting cable, you need to check the [IR SETUP] code signal to see if your VCR can be operated by your camcorder (infrared ray emitter). Remote sensor Infrared ray emitter VCR 100 Dubbing/Editing 1 Touch , then [IR SETUP]. 2 Select the [IR SETUP] code of your VCR with / , then touch . For the [IR SETUP] code of your VCR, refer to "[IR SETUP] code list" (p. 101). When there is more than one code listed for the manufacturer of your VCR, try each code and find the most appropriate one. 3 Touch [PAUSEMODE]. 4 Select the mode to cancel recording pause on your VCR, then touch . Refer to the operating instructions supplied with your VCR for details on operation. 5 Point the infrared ray emitter of your camcorder towards the remote sensor on your VCR, from about 30 cm (12 in.) away, with no obstructions. 6 Insert a cassette into your VCR, and set the VCR to recording pause. 7 Touch [IR TEST]. 8 Touch [EXEC]. The recording starts on your VCR when the setting is correct. [Completed.] appears when the [IR SETUP] code test is finished. Go on to "Step 2 : Adjusting the synchronization of the VCR" (p. 102). When recording fails to start, select another [IR SETUP] code and try again.