Sony DCR-TRV6 Operating Instructions - Page 130
Troubleshooting, In the recording and playback modes
View all Sony DCR-TRV6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Troubleshooting In the recording and playback modes Symptom Cause and/or Corrective Actions The power does not turn on. • The battery pack is not installed, or is dead or nearly dead. c Install a charged battery pack. (p. 10, 11) • The AC power adaptor is not connected to a wall outlet. c Connect the AC power adaptor to a wall outlet. (p. 14) The end search function does not work. •The tape was ejected after recording when using a tape without cassette memory. (p. 24, 27) • You have not recorded on the new cassette yet. (p. 24, 27) The end search function does not work correctly. • The tape has a blank portion in the beginning or middle. The battery pack is quickly discharged. • The operating temperature is too low. • The battery pack is not fully charged. c Charge the battery pack again. (p. 11) • The battery pack is completely dead, and cannot be recharged. c Replace with a new battery pack. (p. 10) The battery remaining indicator does not indicate the correct time. • You have used the battery pack in an extremely hot or cold environment for a long time. • The battery pack is completely dead, and cannot be recharged. c Replace with a new battery pack. (p. 10) • The battery is dead. c Use a charged battery pack. (p. 10, 11) The power goes off although the battery remaining indicator indicates that the battery pack has enough power to operate. c Charge the battery pack fully again so that the indication on the battery remaining indicator is correct. The cassette cannot be removed from the holder. • The power source is disconnected. c Connect it firmly. (p. 10, 14) • The battery is dead. c Use a charged battery pack. (p. 10, 11) The % and Z indicators flash and no functions except for cassette ejection work. • Moisture condensation has occurred. c Remove the cassette and leave your camcorder for at least one hour to acclimatize. (p. 138) indicator does not appear when • The gold-plated connector of the tape is dirty or dusty. using a tape with cassette memory. c Clean the gold-plated connector. (p. 125) Remaining tape indicator is not displayed. • The q REMAIN is set to AUTO in the menu settings. c Set it to ON to always display the remaining tape indicator. (p. 85) 130