Sony DVP-S9000ES Operating Instructions - Page 13
to a receiver amplifier which has a digital, To listen to the sound through speakers connected - player
View all Sony DVP-S9000ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Getting Started Required cords Audio connecting cord (not supplied) (1) White (L) Red (R) S video cord (supplied) (1) White (L) Red (R) When connecting the cords, be sure to match the color-coded cord to the appropriate jacks on the components: Red (right) to Red and White (left) to White. Be sure to make connections firmly to avoid hum and noise. If you have a digital component such as a receiver (amplifier) with a digital connector, DAT or MD, connect the component via the DIGITAL OUT OPTICAL or COAXIAL connector using an optical or coaxial digital connecting cord (not supplied). Optical digital connecting cord (not supplied) (1) Coaxial digital (75 Ω) connecting cord (not supplied) (1) Notes • You cannot enjoy a picture with an S video signal if your TV does not conform to the S video signal. When your TV does not have an S VIDEO input, connect the component via the VIDEO INPUT connector using the audio/video connecting cord (supplied) instead of the S video cord. For details, see page 12. Refer to the instructions supplied with your TV. • You cannot make digital audio recordings of discs recorded in multi-channel surround format directly using an MD deck or DAT deck. • SACD audio signals are not output from the DIGITAL OUT OPTICAL or COAXIAL connectors. When you have made the connections using an optical or coaxial digital connecting cord, do not set "DOLBY DIGITAL" to "DOLBY DIGITAL," "DTS" to "ON" and "48kHz/ 96kHz PCM" to "96kHz/24bit." If you do, a loud noise will suddenly come out from the speakers, affecting your ears or causing the speakers to be damaged. Setups for the player Some setup adjustments are necessary for the player depending on the components to be connected. Use the setup display to change the various settings. For details on using the setup display, see page 50. • To listen to the sound through speakers connected to a receiver (amplifier) which has a digital connector and lacks a built-in DTS or Dolby Digital decoder, or to output the sound to a digital component such as a DAT or MD deck Set the "AUDIO SETUP" items in the setup display (page 60) as shown in the illustration below. These are the default settings. AUDIO SETUP AUDIO ATT: OFF AUDIO DRC: STANDARD AUDIO FILTER SHARP DOWNMIX DOLBY SURROUND DIGITAL OUT: ON DOLBY DIGITAL: D-PCM DTS: OFF 48kHz/96kHz PCM: 48kHz/16bit Set the items as shown To set, press , then ENTER . To quit, press DISPLAY . Note When you output the signals which do not reproduce the Dolby Surround (Pro Logic) effect from the DIGITAL OUT OPTICAL or COAXIAL connector, set "DOWNMIX" to "NORMAL" in "AUDIO SETUP" in the setup display (page 60). 13