Sony EBS-N100 Setup Guide - Page 3

HTML Interface Configuration, Con Submit, Restart - mask

Page 3 highlights

HTML Interface Configuration Once power has been applied to the unit, an IP address must be assigned manually thru the EBSN100's web interface. All EBS-N100's are shipped with a Static IP Address of 192.168.0.10. This IP address can be changed as follow: • Connect the EBS-N100 to a computer with the same sub-net (192.168.0.XXX) • Start the computers browser and enter 192.168.0.10 • The EBS-N100's main web page will appear; select the Configure tab and the following page will appear • Set the desired IP address, Subnet Mask, and Default Gateway and document below: IP Address: • Select Submit and Restart to reboot the unit for the new IP Address to take effect Configuring the Unit Before you begin using the EBS-N100, you must enter the display type and model to which it is connected. The controls available in the user interface (EBS-N100 software) directly correspond to the

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

HTML Interface Configuration
Once power has been applied to the unit, an IP address must be assigned manually thru the EBS-
N100’s web interface.
All EBS-N100’s are shipped with a Static IP Address of 192.168.0.10.
This IP address can be
changed as follow:
Connect the EBS-N100 to a computer with the same sub-net (192.168.0.XXX)
Start the computers browser and enter 192.168.0.10
The EBS-N100’s main web page will appear; select the
Configure
tab and the following page
will appear
Set the desired IP address, Subnet Mask, and Default Gateway and document below:
IP Address:
Select
Submit
and
Restart
to reboot the unit for the new IP Address to take effect
Configuring the Unit
Before you begin using the EBS-N100, you must enter the display type and model to which it is
connected.
The controls available in the user interface (EBS-N100 software) directly correspond to the