Sony ECM-S1 Help Guide - Page 16

Help Guide Wireless/Streaming Microphone ECM-S1 Attaching the connector protect holder/stand Before carrying around the receiver, attach the connector protect holder/stand (supplied) to the receiver. 1 Slide the Multi Interface foot of the receiver into the connector protect holder/stand until it clicks into place. Slightly push down and hold the retention latch ( ) on the connector protect holder/stand, and then slide the receiver into the connector protect holder/stand. To remove the connector protect holder/stand Slightly push down and hold the retention latch ( ) on the connector protect holder/stand, and then pull out the receiver. Hint When placing the receiver away from a camera, attach the connector protect holder/stand to the receiver. Then you can place and use the receiver on a flat surface. The connector protect holder/stand can be screwed to a tripod through the screw hole for tripod attachment (1/4 in. in diameter) on the connector protect holder/stand as well. To screw the connector protect holder/stand to the tripod, use a tripod with the screw that is shorter than 5.5 mm (7/32 in.) in length. To a tripod with the longer screw, the connector protect holder/stand cannot be secured firmly and may be damaged by the screw. Note When you do not intend to use the receiver, attach the connector protect holder/stand to the Multi Interface foot for connector protection. 16