Sony ECM-S1 Help Guide - Page 18

Help Guide Wireless/Streaming Microphone ECM-S1 Recording with the connected camera Use the receiver attached to a camera and the microphone at hand for audio recording. 1 Turn on the camera and place the camera on standby. 2 Turn on the receiver and the microphone. Select your desired audio output with the slide switch (ANALOG/OFF/DIGITAL) on the receiver. If your camera is compatible with the digital audio interface of the Multi Interface Shoe, make sure that the switch is set to "DIGITAL." If not, set the switch to "ANALOG." If the switch is not set correctly, a compatibility message will be displayed on the camera. For camera models compatible with the digital audio interface of the Multi Interface Shoe, visit the website at: https://www.sony.net/dics/ecms1/ Press and hold the (power) button on the microphone for about 2 seconds. Immediately after the receiver and the microphone are turned on, the LINK lamp on the microphone starts blinking slowly in blue. This indicates that each of the devices is making a series of attempts to detect, connect to, and authenticate the other device. When a connection is established between the devices and clear audio recording is possible, the LINK lamps on both devices stay lit in blue. If no connection is established, bring the microphone and the receiver closer to each other for another attempt. The devices may be under influence of environmental or other factors. 3 Make sure that the LINK lamp on the receiver is lit in blue, and then start video recording with the camera. 18