Sony EVID70P Operating Instructions - Page 40

Installing the unit on the ceiling Using the ceiling bracket, retaining wire, and retaining screws supplied, you can utilize existing junction boxes, etc., to attach the camera to the ceiling. When you install the unit, always install it on a level ceiling. If you have to install it on a sloping or uneven ceiling, make sure that the place where you install it is within ±15 degrees of the horizontal. Notes • If you attach the unit to the ceiling, entrust the installation to an experienced contractor or installer. • If you install the unit on the ceiling, be sure the ceiling is strong enough to withstand the weight of the camera plus the ceiling bracket. If the ceiling is not strong enough, the unit may fall and cause serious injury. • If you attach the unit to the ceiling, check periodically, at least once year, to ensure that the connection has not loosened. If conditions warrant, make this periodic check more frequently. Before installation After deciding the direction in which the camera will shoot, make the required holes for the junction box, and connecting cables. Note The connecting cables cannot be passed through ceiling bracket (A). A hole for the wiring is required in the ceiling at the back of the unit where it is attached to the ceiling. Installation 1 Set the IMAGE FLIP switch on the rear panel to ON. Notes • If you set the IMAGE FLIP switch to ON after turning on the power, the image will not be flipped. Turn the power off once, then on again, and the image will be flipped. It may take as long as 7 seconds for the image to appear with the correct orientation. • When you toggle the IMAGE FLIP switch, the pre-set settings will all be returned to the initial settings. 2 Attach the retaining wire to the junction box in the ceiling. Use a screw hole and a screw (not supplied) in the junction box to attach the retaining wire. Ceiling Hole for connecting cable GB 40 Preparations