Sony FCBIX11AP User Manual (FCB-IX11a_tech_manual) - Page 6
Focus, Digital Zoom ON/OFF
View all Sony FCBIX11AP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Basic Functions Zoom The FCB series camera employs an 10× optical zoom lens combined with a digital zoom function allowing you to zoom up to 40×. Lens specifications: Optical 10×, f = 4.2 to 42 mm (F1.8 to F2.9) The horizontal angle of view is approximately 46 degrees (wide end) to 4.6 degrees (tele end). Digital Zoom enlarges the center of the subject by expanding each image in both the vertical and horizontal directions. When 40× zoom is used, the number of effective picture elements in each direction reduces to 1/4 and the overall resolution deteriorates. You can activate the zoom in the following two ways: • By pressing the TELE or WIDE button on the camera itself. • Using a VISCA Command Using Standard Mode Using Variable Mode There are eight levels of zoom speed. Direct Mode Setting the zoom position enables quick movement to the designated position. Digital Zoom ON/OFF In these standard and variable Speed Modes, it is necessary to send a "Stop Command" to stop the zoom operation. • The Zoom Mode supports a Combined Mode and a Separate Mode. Combined Mode This is the previously existing zoom method. After the optical zoom has reached its maximum level, the camera switches to Digital Zoom Mode. Separate Mode In this mode, Optical Zoom and Digital Zoom can be operated separately. You can use digital zoom magnification at any time from within any level of optical magnification. Focus Focus has the following modes, all of which can be set using VISCA Commands. • Auto Focus Mode The minimum focus distance is 10 mm at the optical wide end and 1000 mm at the optical tele end, and is independent of the digital zoom. The AutoFocus (AF) function automatically adjusts the focus position to maximize the high frequency content of the picture in a center measurement area, taking into consideration the high luminance and strong contrast components. - Normal AF Mode This is the normal mode for AF operations. - Interval AF Mode The mode used for AF movements carried out at defined intervals. The time intervals for AF movements and for the timing of the stops can be set in one-second increments using the Set Time Command. The initial value for both is set to five seconds. - Zoom Trigger Mode When the zoom is changed with the TELE button, WIDE button, VISCA Zoom commands or key switches, the pre-set value (initially set at 5 seconds) becomes that for AF Mode. Then, it returns to Manual Focus mode. AF sensitivity can be set to either HIGH or LOW. - HIGH Reaches the highest focus speed quickly. Use this when shooting a subject that moves frequently. Usually, this is the most appropriate mode. - LOW Improves the stability of the focus. When the lighting level is low, the AF function does not take effect, even though the brightness varies, contributing to a stable image. When used for 24 hours continuously, initialization of lens system once a day is recommended because this will make the life of lens longer. The Initialize Lens Command takes a little less than 3 seconds to initialize the focus and zoom. • Manual Focus Mode Manual Focus has both a Standard Speed Mode and a Variable Speed Mode. Standard Speed Mode focuses at a fixed rate of speed. Variable Speed Mode has eight speed levels that can be set using a VISCA Command. • One Push Trigger Mode When a Trigger Command is received, the lens moves to adjust the focus for the subject. The focus lens then holds the same position until the next Trigger Command is input. • Infinity Mode The lens is forcibly moved to a position suitable for an unlimited distance. • Near Limit Mode Can be set in a range from 1000 (∞) to C000 (10 mm). 6