Sony FST-GTK2i Operating Instructions - Page 19

General (Except North American model) The display starts flashing as soon as you plug in the power cord even though you have not press ?/1 to turn on the unit. • The demonstration mode started. Press ?/1 (page 10). There is no sound. • Make sure you press the POWER on the back panel. • Press VOLUME + repeatedly (turn VOLUME clockwise on the unit). There is severe hum or noise. • Move the unit away from the source of noise. • Connect the unit to a different wall outlet. • Install a noise filter (commercially available) to the power cord. • Turn off surrounding electrical equipment. The remote does not function. • Remove the obstacles between the remote and the unit. • Move the remote closer to the unit. • Point the remote at the unit's sensor. • Replace the batteries. • Move the unit away from the fluorescent light. • Place the USB device and iPod to the port/connector firmly. (FST-GTK2i only) There is no sound from the subwoofer. • Adjust the subwoofer level to the appropriate level. • Check that the subwoofer cable and power cord are connected securely and correctly. • Make sure you have turned on the subwoofer by pressing SUBWOOFER ON/OFF on the subwoofer. USB device Are you using a supported USB device? • If you connect an unsupported USB device, the following problems may occur. See "Compatible USB devices with this unit" (page 26) for the supported device types. - The USB device is not recognized. - File or folder names are not displayed on this unit. - Playback is not possible. - The sound skips. - There is noise. - A distorted sound is output. "OVER CURRENT" appears. • A problem has been detected with the level of electrical current from the (USB) port. Press POWER on the back panel to turn off the unit and remove the USB device from the (USB) port. Make sure there is no problem with the USB device. If this display pattern persists, contact your nearest Sony dealer. There is no sound. • The USB device is not connected correctly. Press POWER on the back panel to turn off the unit and reconnect the USB device, then turn on the unit and check if "USB MEMORY" lights up in the display. There is noise, skipping, or distorted sound. • Press POWER on the back panel to turn off the unit and reconnect the USB device, then turn on the unit. • The music data itself contains noise, or the sound is distorted. Continued l 19GB Additional Information