Sony FST-GTK2i Operating Instructions - Page 23

Precautions On safety • Completely disconnect the power cord (mains lead) from the wall socket (mains) if it is not going to be used for an extended period of time. When unplugging the unit, always grip the plug. Never pull the cord itself. • Should any solid object or liquid get into the system, unplug the system, and have it checked by qualified personnel before operating it again. • (For customers in United States and Canada only) One blade of the plug is wider than other for the purpose of safety and will fit to the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer. • The AC power cord can be changed only by a qualified service facility. On placement • Do not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. • Be careful when placing the unit or subwoofer on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. On heat buildup • Heat buildup on the unit during operation is normal and is not a cause for alarm. • Do not touch the cabinet if it has been used continuously at a high volume because the cabinet may have become hot. • Do not obstruct the ventilation holes. On the speaker system This speaker system is not magnetically shielded, and the picture on nearby TV sets may become magnetically distorted. In this situation, turn off the TV, wait 15 to 30 minutes, and turn it back on. If there is no improvement, move the speakers far away from the TV. Cleaning the cabinet Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as thinner, benzine, or alcohol. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: RDH-GTK1i USA model only With 6-ohm loads, both channels driven, from 120 Hz - 10 kHz; rated 30 watts per channel minimum RMS power, with no more than 0.7% total harmonic distortion from 250 miliwatts to rated output. Amplifier section FST-GTK2i The following are measured at AC 127 V, 60 Hz Front speaker: Power Output (rated) 35 W + 35 W (at 6 :, 1 kHz, 1% THD) RMS output power (reference) 110 W + 110 W (per channel at 6 :, 1 kHz) Subwoofer: RMS output power (reference) 230 W (8 :, 100 Hz) FST-GTK1i and RDH-GTK1i North American model only The following are measured at AC 120 V, 60 Hz Front speaker: RMS output power (reference) 110 W + 110 W (per channel at 6 :, 1 kHz) Continued l 23GB Additional Information